Inputting from the programmable controller
Set the input data from the programmable controller.
Outputting to the programmable controller
1.
Set the data to be output to the programmable controller.
2.
Set output details.
Set the ON time of the signal to turn ON when processing is completed.
• Range: 1-1000 ms
Click [OK].
Select [Inputs].
Set the Direct 0 signal type to
"Online/Offline".
Select [Outputs].
Check [De-Energize While Offline].
Configure the settings for Direct 0
to 2 as shown left.
Click [Details] of Direct 3.
2 I/O CONNECTION
2.2 Vision Sensor Setting
2
37