Interference With Proximity Sensors - Omron V600 Series Operation Manual

R/W Head Installation

4-1-4 Interference with Proximity Sensors

V600-H07 R/W Head
400 mm min.
Proximity
sensor
V600-H11 R/W Head
100 mm min.
Proximity
sensor
30
V600-series R/W Heads use electromagnetic linking (frequency: 530 kHz), so, if
they are installed near sensors (such as proximity sensors) with an oscillation
frequency of 400 to 600 kHz, it may cause the sensors to malfunction. Before
installing R/W Heads, and when selecting sensors, be sure to conduct tests to
make sure that there will be no interference.
As shown in the following diagrams, a V600-H07 R/W Head should be at least
400 mm from a proximity sensor when the two are facing the same direction or
perpendicular. When the two are facing each other, they should be at least 300
mm apart.
Proximity
sensor
400 mm min.
As shown in the following diagrams, a V600-H11 R/W Head should be at least
100 mm from a proximity sensor regardless of whether the two are parallel, per-
pendicular, or facing each other.
Proximity
sensor
100 mm min.
300 mm min.
Proximity
sensor
100 mm min.
Proximity
sensor
Section 4-1
V600-H07
V600-H11