Registering The Telephone; Registering The Telephone On A System For The First Time - Alcatel-Lucent 8244 DECT Handset User Manual

Registering the telephone

7 Registering the telephone

7.1 Registering the telephone on a system for the first time

For the mobile telephone to function, it must be registered on at least one Alcatel-Lucent Enterprise or
GAP system (registration operation). Your telephone has not yet been registered on any system if, when
first switched on, the display indicates:
•
Auto install?
•
Confirm.
•
Register
•
Select a system (It is recommended that the first empty system is selected).
•
Apply (Ok).
•
Enter PARK code (Enter nothing if not mandatory).
ghi kl
p r s t uv •
Apply (Ok).
•
Enter access code (Enter nothing if not mandatory).
ghi
kl
p r s t uv •
Apply (Ok).
•
Power mode:
Select the power mode using the corresponding softkeys:
are advised not to select the 50 mW power mode unless required. The '50mW power
mode' is intended for hazardous sites such as nuclear plants where it is requested
that emissions do not exceed the maximum value.).
•
Enhanced Security
•
Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
•
Select 'Modic' mode:
The registration operation can last up to 2 minutes.
•
If the operation has been done correctly (subscription accepted), the telephone is ready to be used
and the radio reception quality icon is displayed.
•
If the registration operation has not been successful, the station proposes launching the
subscription again.
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will be
considered under the terms of the warranty.
During registration phase, to improve security and optimize registration in a multi-system environment, the
handset enforces a minimum signal strength level to accept to register to a base station. To achieve the
conditions, it is recommended to perform registration in a place where a base station is in direct visibility
within a 20 m range. If base station is not visible the range shall be lowered.
8AL90396ENAAed01
Auto install?
o Select '8244 Modic' if you connect the handset to an OXO Connect R4.0 and
more, otherwise select '8242 Modic'.
o Select '8242 Modic' if you connect the handset in IP-DECT mode.
Normal / 50 mW power
57 /90
(you