Registering The Telephone; Registering The Telephone On A System For The First Time - Alcatel-Lucent 8212 User Manual

8212 DECT Handset - SIP User manual

4 Registering the telephone

4.1 Registering the telephone on a system for the first time

If, when first switched on, the display indicates: 'System 1 Auto install ?', your handset has not been
registered on any system. The base station should be ready to register a new handset.
•
Auto install?
•
Confirm.
Registration can begin.
A- If the system does not use an AC code.
•
Launch subscription.
B- If the system uses an AC (authentication code).
•
Register
•
Enter the PIN Code (The default is 0000).
•
Apply.
•
Select a system (It is recommended that the first empty system is selected).
•
Apply.
•
Enter PARK code (Enter nothing if not mandatory).
•
Apply.
•
Enter access code (Enter nothing if not mandatory).
•
Apply.
•
Select the Power mode (You are advised not to select the 50 mW power mode unless
required. The '50mW power mode' is intended for hazardous sites such as nuclear plants
where it is requested that emissions do not exceed the maximum value.).
•
Enhanced Security
•
Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
•
8212_SIP MODIC
Select this mode if your phone is connected to an 8328 SIP-DECT Single Base Station.
The registration operation can last up to 2 minutes.
•
If the operation has been done correctly (subscription accepted), the telephone is ready to be used
and the radio reception quality icon is displayed.
•
If the registration operation has not been successful, the station proposes launching the subscription
again.
During registration phase, to improve security and optimize registration in a multi-system environment,
the handset enforces a minimum signal strength level to accept to register to a base station. To achieve
the conditions, it is recommended to perform registration in a place where a base station is in direct
visibility within a 20 m range. If base station is not visible the range shall be lowered.
During registration phase in a multi-system environment, all systems are scanned without priority. The
system is selected when the signal strength is above a certain level and registration matches.
8AL91447ENAAed01
24/32