Camera Connections - Bosch MIC inteox 7100i Installation Manual

MIC inteox 7100i
13.4

Camera Connections

All electrical and data connections from the camera are made from the connectors in the base
of the camera.
Figure 13.1: Connectors from the base of the MIC camera
1 Chassis (Earth) ground wire (18 gage) with connector lug
2 24 VAC power wires (24 gage) to Pins 4 and 5 of connector labeled P107 in
VG4-A-PSU1 or VG4-A-PSU2 (if not using a High PoE network)*
3 RS-485 connections for communication to / from the MIC-ALM-WAS-24 or other
device providing legacy serial protocol signals *
4 RJ45 (Cat5e/Cat6) connector (male) (supporting High PoE) for power and
communication between a Bosch High PoE Midspan
5 Audio wires (twisted pair cable recommended)
6 Wire connectors on 9 wires (numbers 2, 3, and 5 in the corresponding graphic)
Note: The quick clips should remain on unused wires. If the clips are removed,
cover the exposed copper on the wires with electrical tape to prevent the
unused wires from electrically shorting to one another or to the mount
enclosure.
7 RJ45 coupler (female to female)
* [Not available on MIC inteox models.]
* For more information, refer to the installation manual Power Supply Units (AUTODOME VG5-
and MIC IP Camera Models) (shipped with VG4-A-PSU1 and VG4-A-PSU2).
Bosch Security Systems
Description
Installation Manual
Connection | en
Wire Color
Green
Line (L) = Black
Neutral (N) = White
+ = Purple
- = Yellow
GND = Brown
Audio IN + = Red
Audio IN - = Light blue
Audio OUT + = Orange
Audio OUT - = Dark blue
2021-03 | 1.2 |
37