Tig Welding; Smaw Welding - Lincoln Electric POWER WAVE 300C Operator's Manual

POWER WAVE 300C
®

TIG WELDING

(Figure A.7)
TIG uses Electrode Negative Polarity so for this appli-
cation, connect the Tig torch to the negative (-) output
stud (standard model) or electrode stud (advanced
model) and connect the work clamp to the positive (+)
output stud (standard model) or electrode stud
(advanced model) The TIG torch gas connection
should be connected to the POWER WAVE 300C's
internal gas supply connection. If required a foot
amptrol can be connected to the remote control
receptacle.
WORK
FOOT PEDAL
TIG TORCH
TIG ADVANCED MODEL
TIG TORCH
WORK
TIG - STANDARD MODEL

SMAW WELDING

Most SMAW welding procedures use Electrode
Positive welding. For these applications, connect the
stick electrode holder to the positive (+) output stud
(standard model) or electrode stud (advanced model)
and connect the work clamp to the negative (-) output
stud (standard model) or electrode stud (advanced
model).
®
Some SMAW welding procedures use Electrode
Negative Polarity. For these applications, connect the
stick electrode holder to the negative (-) output stud
and connect the work clamp to the positive (+) output
stud on the standard model.
The advanced model has the ability to self configure
the electrode polarity based on the UI selection.
FIGURE A.7
WORK
MIG - STANDARD AND ADVANCED MODELS
WORK
STICK - STANDARD AND ADVANCE MODELS
A-12
INSTALLATION