If A Menu Screen Appears - Alpine IVA-D100 Owner's Manual

Mobile multimedia station

Hide thumbs Also See for IVA-D100:

Owner's manual (240 pages)

Service manual (119 pages)

Table Of Contents

Table of Contents

Enlarged version

Caution

• Not all functions will operate for every DVD. See the

individual DVD's instructions for details on the

features supported.

• Fingerprints on a disc may adversely affect

playback. If a problem occurs, remove the disc and

check for fingerprints on the playback side. Clean

the disc if necessary.

• If you switch the power or Ignition Key OFF or

change sources during playback, playback will

continue where you left off when you resume

playback.

• If you try to perform an invalid operation (based on

the type of disc being played), the following mark is

displayed on the monitor screen:

• Play Position Memory Function

Even if you turn power off or switch the Ignition Key

to OFF during playback or change the source,

playback will continue from the point where

playback stopped when the power is turned ON

again.

Press SOURCE/POWER.

The source selection screen is displayed.

Touch [

] of DVD PLAYER.

The display shows the DVD player mode screen.

Insert a disc with the label side facing up. The unit starts to

play the disc.

When an optional Alpine DVD player is connected:

Insert a disc into the DVD/video CD/CD player, the player

starts playing.

• The operation screen changes to the visual screen in the DVD or

video CD mode for 5 seconds after an operation has been performed.

Touch the display panel to display the operation screen again.

• The display mode can be changed by touching [WIDE].

For operation, see "Switching Display Modes" on page 26.

To eject the disc

Press

• The reverse side of a double-sided DVD will not be played

automatically.

Remove the disc, turn it over, and reinsert it.

• If the disc does not eject, press and hold

• DO NOT insert discs containing maps for the navigation system.

Doing so could result in damage.

• Refer also to "DVD Setup" (pages 28 to 32).

• Be sure the remote input lead is connected to the remote output lead

of this unit when a DVD changer or DVD player is connected. If not

correctly connected, touch operation cannot be performed.

• To return to the previous screen during video CD playback, touch

[RTN] after touching [PAGE1/2] of the function guide. However, the

function may vary depending on the disc.

• If the disc is left in the unit after pressing

pulled back into the unit and stopped. In this case, start playback by

touching [

] or eject again and remove the disc within 15

seconds.

On DVDs and Video CDs with playback control (PBC), menu screens

may appear automatically. If this happens, perform the operation

described below to start playback.

• To play back a DVD-Audio disc, set "VCAP" in "Setting the DVD-

Direct Menu Operations

Menu Operations

for at least 2 seconds.

, the disc is automatically