Table of Contents
Advertisement
Playing a Disc
IVA-D106R has a built-in DVD player. When an optional Alpine
DVD/Video CD/CD player (or DVD changer) is connected to the
IVA-D106R, you can control it from the IVA-D106R. (except some
operations)
WARNING
It is dangerous for the driver to watch the TV/DVD/
Video while driving the vehicle. The driver may be
distracted from looking ahead and an accident could
occur.
Install the IVA-D106R correctly so that the driver
cannot watch TV/DVD/Video unless the vehicle is
stopped and the emergency brake is applied.
If the IVA-D106R is not installed correctly, the driver
will be able to watch the TV/DVD/Video while driving
the vehicle and may be distracted from looking ahead
causing an accident. The driver or other people could
be severely injured.
To display the DVD mode screen
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
Caution
• Not all functions will operate for every DVD. See the
individual DVD's instructions for details on the
features supported.
• Fingerprints on a disc may adversely affect
playback. If a problem occurs, remove the disc and
check for fingerprints on the playback side. Clean
the disc if necessary.
• If you switch the power or Ignition Key OFF or
change sources during playback, playback will
continue where you left off when you resume
playback.
• If you try to perform an invalid operation (based on
the type of disc being played), the following mark is
displayed on the monitor screen:
• Play Position Memory Function
Even if you turn power off or switch the Ignition
Key to OFF during playback or change the source,
playback will continue from the point where
playback stopped when the power is turned ON
again.
1
Touch [SOURCE] on the main source screen.
The SOURCE selection screen is displayed.
2
Touch [DVD PLAYER].
The display shows the DVD mode screen.
Insert a disc with the label side facing up. The unit starts to
play the disc.
When an optional Alpine DVD is connected:
Insert a disc into the DVD/Video CD/CD player, the player
starts playing.
• The operation screen changes to the visual screen in the DVD or
Video CD mode for 5 seconds after an operation has been performed.
Touch the display panel to display the operation screen again.
• The display mode can be changed by touching [WIDE].
For operation, see "Switching Display Modes" on page 28.
To eject the disc
Press
.
• The reverse side of a double-sided DVD will not be played
automatically.
Remove the disc, turn it over, and reinsert it.
• If the disc does not eject, press and hold
• Do not insert discs containing maps for the navigation system. Doing
so could result in damage.
• Refer also to "DVD Setup" (pages 30 to 34).
• Be sure the remote input lead is connected to the remote output lead
of this unit when a DVD changer or DVD player is connected. If not
correctly connected, touch operation cannot be performed.
• To return to the previous screen during Video CD playback, touch
[RETURN] after touching [P1/2] of the function guide. However, the
function may vary depending on the disc.
• If the disc is left in the unit after pressing
automatically pulled back into the unit and stopped. In this case,
start playback by touching [
disc within 15 seconds.
• While "INDEX READING" is displayed by DivX
forwarding/fast-reversing and repeat functions, etc. cannot be used.
If a menu screen appears
On DVDs and Video CDs with playback control (PBC), menu screens
may appear automatically. If this happens, perform the operation
described below to start playback.
• To play back a DVD-Audio disc, set "VCAP" in "Setting the DVD-
Audio Playback Mode" (page 33).
Direct Menu Operations
1 Touch the DVD menu directly.
• Some operations cannot be performed depending on the disc.
Menu Operations
for at least 3 seconds.
, the disc is
/
] or eject again and remove the
®
, the fast-
19
-EN
Advertisement
Table of Contents
