General Specifications - Pentair MASTERTEMP 200HD Installation And User Manual

6
SAFETY INFORMATION,
WARNING — Risk of fire or explosion from flammable vapors. Do not store gasoline, cleaning fluids, varnishes,
paints, or other volatile flammable liquids near heater.
WARNING — Risk of explosion if unit is installed near propane gas storage. Propane (LP) gas is heavier than
air. Consult local codes and fire protection authorities about specific installation requirements and
restrictions. Locate the heater away from propane gas storage and filling equipment as specified by
the Standard for the Storage and Handling of Liquefied Petroleum Gases (latest edition).
WARNING — Risk of fire. Do not place articles on, near or against the heater.
WARNING — Risk of burn hazard. To reduce the risk of injury, do not touch the side heater vent cover when the
heater is operating. Side heater vent covers are HOT and can burn when touched causing personal
injury. Do not allow children to play on or around heater or associated equipment.
Vent
Cover
WARNING — Risk of asphyxiation if exhaust is not correctly vented. Follow venting instructions exactly
when installing heater. Do not use a drafthood with this heater, as the exhaust is under pressure
from the burner blower and a draft hood will allow exhaust fumes to blow into the room housing the
heater. The heater is supplied with an integral venting system for outdoor installation.
CAUTION — Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation. Wiring errors can also destroy the control board.
• Connect heater to 230-240 Volt, 50 Hz., Single Phase power only.
• Verify proper operation after servicing.
• Do not allow children to play on or around heater or associated equipment.
• Never allow children to use the pool or spa without adult supervision.
• Read and follow other safety information contained in this manual prior to operating this pool heater.

GENERAL SPECIFICATIONS

NOTICE:
• Combustion air contaminated by corrosive chemical fumes can damage the heater and will void the warranty.
• The Combination Gas Control Valve on this heater differs from most appliance gas controls. If it must be replaced,
for safety reasons replace it only with an identical gas control.
• The access door panels must be in place to provide proper ventilation. Do not operate the heater for more than five (5)
minutes with the access door panels removed.
• This heater is design certified by IAPMO as complying with the Standard for Gas Fired Pool Heaters, and is intended
for use in heating fresh water swimming pools or spas.
• The heater is designed for the heating of chlorine, bromine or salt system swimming pools and spas. It should NOT be
used as a space heating boiler, or general purpose water heater. The heater requires an external 230-240 VAC
single-phase electric power source.
• The heater should be located in an area where leakage of the heater or connections will not result in damage to the
area adjacent to the heater or to the structure. When such locations cannot be avoided, it is recommended that a
suitable drain pan, adequately drained, be installed under the heater. The pan must not restrict air flow.
• The heater may not be installed within 3000 mm of the inside surface of a pool or spa unless it is separated by a
solid fence, wall or other permanent barrier.
MasterTemp Pool and Spa Heater
(continued)
P/N 474131 Rev. M 8/2020