Safety Warnings; Important Notices / Warranty Information - Pentair MASTERTEMP 200HD Installation And User Manual

Introduction
MasterTemp Pool and Spa Heater
Congratulations on your purchase of a MasterTemp high performance heating system. Proper installation and service of
your new heating system and correct chemical maintenance of the water will ensure years of enjoyment. The MasterTemp
is a compact, lightweight, efficient, induced-draft, gas fired high performance pool and spa heater that can be directly
connected to 50 mm PVC pipe. The MasterTemp heater also comes equipped with the Pentair multifunction temperature
controller which shows, at a glance, the proper functioning of the heater. All MasterTemp heaters are designed with a
direct ignition device, HSI (hot-surface ignition), which eliminates the need for a standing pilot. The MasterTemp requires
an external power source (230-240 VAC, 50 Hz) to operate.
SPECIAL INSTRUCTIONS TO OWNER: Retain this manual for future reference. This instruction manual provides
operating instructions, installation and service information for the MasterTemp high performance heater. The information
in this manual applies to all MasterTemp models. READ AND REVIEW THIS MANUAL COMPLETELY, it is very
important that the owner/installer read and understand the section covering installation instructions, and recognize the local
and state codes before installing the MasterTemp. Its use will reduce service calls and chance of injury and will lengthen
product life. History and experience has shown that most heater damage is caused by improper installation practices.
IMPORTANT NOTICES
THE MASTERTEMP HEATER MUST BE INSTALLED BY A REGISTERED INSTALLER OR A
QUALIFIED GAS PLUMBER AND SERVICED BY A PROFESSIONAL SERVICE TECHNICIAN,
QUALIFIED IN POOL HEATER INSTALLATION. SUCH INSTALLATION WILL COMPLY WITH CODE
REQUIREMENTS LISTED ON PAGE 4.
NOTICE: THE MASTERTEMP HEATER IS INTENDED FOR INSTALLATION WITH A METERED GAS PRESSURE
REGULATOR CAPABLE OF DELIVERING 1.0 - 6.0 kPa GAS PRESSURE TO THE MASTERTEMP GAS VALVE.
For the installer and operator of the MasterTemp pool and spa heater: The manufacturer's warranty may
be void if, for any reason, the heater is improperly installed and/or operated. Be sure to follow the instructions set
forth in this manual. If you need more information or if you have any questions regarding to this pool heater, please
contact
Pentair Water Australia Pty. Ltd. AU/NZ, AUS – at 1300 137 344 or + 61 3 9709 5800.
WARRANTY INFORMATION
The MasterTemp pool heater is sold with a limited factory warranty.
High standards of excellence include a policy of continuous product improvement results in your state-of-the-art heater.
We reserve the right to make improvements which change the specifications of the heater without incurring an obligation
to update the current heater equipment.
These heaters are designed for the heating of chlorine, bromine or salt system swimming pools and spas or in
non-stationary installations, and should never be employed for use as space heating boilers or general purpose
water heaters. The manufacturer's warranty may be void if, for any reason, the heater is improperly installed
and/or operated. Be sure to follow the instructions set forth in this manual.
OPERATING THIS HEATER CONTINUOUSLY AT WATER TEMPERATURE BELOW 20°C. WILL CAUSE HARMFUL
CONDENSATION AND WILL DAMAGE THE HEATER AND VOID THE WARRANTY. Do not use the heater to protect pools
or spas from freezing if the final maintenance temperature desired is below 20°C., as this will cause condensation
related problems.
P/N 474131 Rev. M 8/2020
CAUTION
Section 2. Introduction
MasterTemp Pool and Spa Heater
3