Gas Pipe Escutcheon Installation
The gas pipe escutcheon ensures the heater is rodent resistant. The following describes how to install the round
gas pipe escutcheon for a new heater installation. The gas pipe escutcheon should be installed when the gas pipe
is being installed to the heater. See page 61 for parts list.
To install the gas pipe escutcheon:
1. Place the gas pipe escutcheon over the gas pipe, see Figure 10.
2. Install the gas pipe as described in the heater manual.
3. Slide the escutcheon flush against the heater panel.
4. Hand-tighten the retention screw to secure the escutcheon in place.
Tool: Phillips Screwdriver
Figure 9. Flange installed on the
pipe. Be sure the flange covers the
circular opening in the heater
panel.
Figure 10.
P/N 474131 Rev. M 8/2020
Section 1.
Flange
Screw
MasterTemp Pool and Spa Heater
Installation
17