Installation - Alpine CDA-9825 Owner's Manual

Installation

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit
and may cause a fire.
Air ventilation
hole
1
No Pressure Here
No Pressure Here
Remove the Detachable Front Panel (refer to page 5). Slide
mounting sleeve from main unit. (see "Removal" on this
page).
Slide the mounting sleeve into the dashboard.
NOTE
Please examine the installation. Make certain that no external
pressure is applied to either the top of the unit or the removable
nosepiece.
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
∗
metal spot using a screw (
vehicle's chassis.
NOTE
For the screw marked , use an appropriate screw for the
**
chosen mounting location.
<Rear side>
Mounting Sleeve
(Included)
Dashboard
This unit
Screw
∗∗
Bolt Stud
∗
This unit
Chassis
) already attached to the
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the CDA-9827/CDA-9825. Connect all other
leads of the CDA-9827/CDA-9825 according to details
described in the CONNECTlONS section.
3
Lock Pin
Slide the CDA-9827/CDA-9825 into the dashboard. When
the unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by pressing
firmly in on the unit while pushing the locking pin down with
a small screwdriver. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard. Install the Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
This unit
Ground Lead
∗
NOTE
Secure the ground lead of the unit to a clean metal spot using a
∗
screw ( ) already attached to the vehicle's chassis.
Face Plate
Screws (M5 × 8)
(Included)
Mounting Bracket
35
-EN