Switching The Phase Of The Subwoofer Output; Setting The Subwoofer Output - Alpine CDA-7878 Owner's Manual

Basic Operation
g DN
Switching the Phase of the
Subwoofer Output
You can switch the phase of the subwoofer output
to NORMAL 0˚ or REVERSE 180˚.
To select the desired phase.
1
Press and hold the SETUP button for at least 2
seconds.
2
Press the fUP button to select "Switching the
phase of the SUB-W (SUB-W NORMAL or
REVERSE) mode."
TUNER SUB-W
DEMO
CONTRAST
AUX MUTE
∗ Displayed when you set SUB-W to ON.
NOTE
If you press the g DN button, the display scrolls in
reverse sequence.
3
Press the TUNE button to select NORMAL (0˚) or
REVERSE (180˚).
NOTE
The initial setting at the factory is SUB-W NORMAL.
4
Press the SETUP button to set the selected
mode.
8
-EN
TUNE
f UP
SETUP
SUB-W (switching phase) ∗
SUB-W STEREO/MONO ∗
SRC DHE
DISC/FOLDER
SCROLL BEEP

Setting the Subwoofer Output

You can set the subwoofer output to stereo or
monaural.
Make sure to set the correct output for your
subwoofer type.
1
Press and hold the SETUP button for at least 2
seconds.
2
Press the fUP button to select "Switching the
SUB-W monaural/Stereo (SUB-W STEREO or
MONO) mode."
TUNER SUB-W
DEMO
CONTRAST
AUX MUTE
∗ Displayed when you set SUB-W to ON.
NOTE
If you press the g DN button, the display scrolls in
reverse sequence.
3
Press the TUNE button to select SUB-W
STEREO or MONO.
SUB-W STEREO:
Subwoofer stereo (L/R) output
SUB-W MONO:
Subwoofer monaural output.
NOTE
The initial setting at the factory is SUB-W STEREO.
4
Press the SETUP button to set the selected
mode.
SUB-W (switching phase) ∗
SUB-W STEREO/MONO ∗
SRC DHE
DISC/FOLDER
SCROLL BEEP