Authentication Type - Alfa Network AIP-610H User Manual

Step 2. If the linking is established successfully. It will show the message"Connect
successfully". Then press "OK".
Step 3. Then you can check the linking information in "Status" page.
Note: If the available network requires authentication and data encryption, you need to
setup the authentication and encryption before step1 and all the settings must be
as same as the Access Point or Station. About the detail authentication and data
encryption settings, please refer the security section.

Authentication Type

In client mode, the device also supports two Authentication Types "Open system" and
"Shared Key". Although the default setting is "Auto", not every Access Points can
support "Auto" mode. If the authentication type on the Access Point is knew by user, we
suggest to set the authentication type as same as the Access Point.