Honeywell MAXPRO MPIP2000U Series Installation And Setup Manual page 77

Honeywell MAXPRO Intrusion MPIP2000U/3000U Series
To mount the device on the wall in its own enclosure, proceed as follows:
1. Press the tab at the bottom of the lid and remove the lid.
2. Fix the device to the wall using the 4 large screws (A).
B
B
A Opening for wiring (x 3)
B Mounting screw (x 4)
C Tamper screw (x 1). Required
for off-wall tamper protection.
3. Screw the tamper screw (C) into the wall. This screw provides off-wall
tamper protection.
4. For wiring, see Summary of Connections on page 78.
5. Use cable ties to bundle and fix wiring. The PCB holder has various
attachments point for this purpose.
6. Click the lid back in place and fix it using the small lid screw (E).
800-23044 Rev. A draft_11
A
A D
Installation and Setup Guide
B
C
B
D LED indicator
E Lid screw (x 1)
77