Jeep CHEROKEE User Manual page 178

Fuel And AdBlue® (UREA) Filler Location
1 — AdBlue® (UREA) Filler Cap
2 — Fuel Filler
Refilling With Nozzles
You can fill up at any AdBlue® (UREA)
distributor.
Proceed as follows:
Insert the AdBlue® (UREA) nozzle in the

filler, start refilling and stop refilling at the
first shut-off (the shut-off indicates that
the AdBlue® (UREA) tank is full). Do not
proceed with the refilling, to prevent
spillage of AdBlue® (UREA).
Extract the nozzle.

176
Refilling With Containers
Proceed as follows:
Check the expiration date.

Read the advice for use on the label before

pouring the content of the bottle into the
AdBlue® (UREA) tank.
If systems which cannot be screwed in

(e.g. tanks) are used for refilling, after the
indication appears on the instrument
panel display refer to "Warning lights And
Messages" in the "Getting To Know Your
Instrument Panel" for further information,
fill the AdBlue® (UREA) tank with no
more than 1.6 Gallons (6 liters).
If containers which can be screwed to the

filler are used, the reservoir is full when
the AdBlue® (UREA)
container stops pouring out. Do not
proceed further.
Operations After Refilling
Proceed as follows:
Fit the cap back on the AdBlue® (UREA)

filler by turning it clockwise and screwing
it completely.
Place the ignition to RUN (it is not neces-

sary to start the engine).
Wait for the indication on the instrument

panel to switch off before moving the car.
The indication may stay on for a few
seconds to approximately half a minute. If
the engine is started and the car is moved,
the indication will remain on for longer.
This will not compromise engine opera-
tion.
If the AdBlue® (UREA) was topped up

level in the when the tank was empty, wait for
2 minutes before starting the engine.