Jeep CHEROKEE User Manual page 133

Suitability of Passenger Seats for i-Size
Child Restraint System Use
The rear outboard seats of the vehicle are
type-approved to house the state-of-the-art
i-Size child restraint systems.
These child restraint systems, built and
type-approved according to the i-Size (ECE
R129) standard, ensure better safety condi-
tions to carry children on board a vehicle:
The child must be transported rearward

facing until 15 months:
Child restraint system protection

increased in the event of a side collision:
The use of the ISOFIX system is promoted

to avoid faulty installation of the child
restraint system:
Efficiency in the choice of the child

restraint system, which
according to weight
according to the child's
increased:
Compatibility between the vehicle seats

and the child restraint systems is better:
the i-Size child restraint systems can be
considered as "Super ISOFIX"; this means
that they can be perfectly fitted in
type-approved i-Size seats, but can also be
fitted in ISOFIX (ECE R44) type-approved
seats.
is
NOTE:
The vehicle seats, i-Size type-approved, are
marked by the symbol shown in Figure XX.
The following table, according to European
standard ECE 129, indicates the possibility
of i-Size child restraint system installation.
i-Size Child Seat Position Table
isn't made
Device
anymore but
height, is
i-Size
Child
Restraint
Systems
Key of letters used in the table above:
i-U = Suitable for Universal i-Size child

restraint systems, both rearward facing
and forward facing.
X = Seat not suitable for Universal i-Size

child restraint systems.
Front Rear Rear
Pas- Out- Center
senger board
ISO/ X i-U X
R2
ISO/ X i-U X
F2
131