Table of Contents
Advertisement
Step 3
Insert Barrel Nut (B) into the Side Rail Top Front (8) and Side Top Back (9). Attach To the 2 Headboard
Top (1) using Bolt M6 x 100mm (D) and tighten using a Phillips Head Screwdriver as shown in
the diagram below. Repeat this process at each end of the bed as shown below.
Step 4
Starting at one end of the bed, secure the rst tted slat into place using Screw (C). Next secure the tted slat
to the other ebd using Screw (C) ensuring that there are no gaps between the slats and headboard. Finally secure
the rest of the slats into place using Screw (C) and a Philips Head Screwdriver as show in the diagram below.
Please Note: This is the top half of the bunk bed
Please Note: The slats at each end have been cut to allow them to
sit flush with NO GAPS between the headboard and slats.
Advertisement
Table of Contents
