Table of Contents
Advertisement
Step 1
Insert Barrel Nut (B) into the Side Rail Bottom Front (10) and Side Rail Bottom Back (11). Attach the
Headboard Bottom (2) using Bolt M6 x 100mm (D) and tighten using Allen Key M4 (A). Repeat this
process at each end of the bed as shown in the diagram below.
Please Note: One of the bottom Side Rails (10) and one of the Top Side Rails (8) have additional
pre-drilled holes for the Ladder to bed attached meaning the Ladders can be placed on either end of
the bed so you need to decide the positioning before starting to assemble the bed.
Step 2
Starting at one of the bed, secure the first fitted slat into place using Screw (C). Next, secure the fitted
slat to the other end and secure using Screw (C) ensuring that there are no no gaps between the slats
and the Headboards. Finally secure the rest of the slats into place using Screw (C) as shown in the diagram
below using a Phillips Head Screwdriver.
Please Note: The slats at each end have been cut to allow them to
sit flush with NO GAPS between the headboard and slats.
Advertisement
Table of Contents
