Board Frame - Sony Ericsson K800 Working Instruction, Mechanical

4. Insert the new camera module into its cavity.
5. Press on the pad on the back of the camera
module until is completely seated in the board
frame.
•

4.21 Board Frame

Replacement Procedure
•
Perform sections 2.1 - 2.9 of the Disassembly Procedure.
NOTE!
1. Push on the lens side of the rear camera
module so that the camera module falls out of
its cavity in the old board frame.
2. Remove the vibrator from the old board frame
by lifting up on the exposed bottom edge of the
vibrator using the flat end of a pry tool.
3/00021-1/FEA 209 544/112 A
Company Internal © Sony Ericsson Mobile Communications AB
Perform sections 3.1 – 3.9 of the reassembly procedure
Do not push directly on the camera's
lens!
Step-by-Step Instructions
Step-by-Step Instructions
Working Instruction, Mechanical
64(74)