3.2
1. While holding the keypad assembly upside
down over the rear camera, plug the keypad
assembly's flex film into its connector on the
circuit board.
2. Rotate the keypad onto the portion of the circuit
board adjacent to the system connector.
3.3
1. Verify that the flex film extending from the LCD
is behind the two features of the LCD holder
that are indicated.
2. Hold the LCD assembly over the circuit board
as shown and plug the LCD assembly's flex film
into its connector on the circuit board.
3/00021-1/FEA 209 544/112 A
Company Internal © Sony Ericsson Mobile Communications AB
Keypad Connection to Circuit Board
LCD Connection to Circuit Board
Step-by-Step Instructions
Step-by-Step Instructions
Working Instruction, Mechanical
20(74)