Determine Alarm Groups; Change Master Code - TCS FIL1101-0140 Product Information

Determine alarm groups

Initiate
programming
enter
correct value has been
entered
incorrect value has
been entered
* WE = factory setting

Change master code

Initiate
programming
enter
correct master code
and correct value have
been entered
incorrect entry, unk-
nown master code
TCS TürControlSysteme AG, TCS Hotline Germany:
FAX: +49 (0) 41 94/ 9 88 129  Mail: hotline@tcsag.de
16
If not yet done
* 7x # alarm group #
...
.
.
x = 1 alarm group 1
.
= 2 alarm group 2
...
= 3 alarm group 3
alarm group
= 0 to 63
 A positive acknowledgement tone sounds,
LED, red acknowledges with selected flash-
ing sequence (e.g.flashing 1:7), duration 5 s.
Then the red LED is ON for 3 s.
 Then the red LED blinks.
The alarm group is stored.
A negative acknowledgement tone sounds
when pressing the #-key.
The the red LED blinks fast for 3 s,
then blinks again.
If not yet done
* 98 # old master code #
...
new master code # new mastercode #
master code = number with 6 digits
ATTENTION: For safety reasons, the
!
preset master code should be
changed when commissioning!
 A positive acknowledgement tone sounds,
the red LED is ON for 3 s.
 then the red LED blinks.
The new master code has been stored.
A negative acknowledgement tone sounds
when pressing the #-key.
The red LED blinks fast for 3 s,
then blinks again.
(alle WE* = 63)
Subject to technical changes.
FIL1101 UK 1A
05/2013
mi