Parallel Allocation To Serial Numbers 1 And 2; Select Sound Profile And Ring Tones - TCS FIL1101-0140 Product Information

05/2013

Parallel allocation to serial numbers 1 and 2

 Further (sub) indoor stations or signal units can be allocated to a main indoor station
(indoor station with handset or for simplex communication). When the main indoor sta-
tion is called, also the signal unit chimes. A direct call to the sub-indoor station or the al-
located signal unit is not indicated at the main indoor station.
 If there are more than 2 devices connected in parallel, all devices must be supplied by
P-wire (3-wire operation).
 The FIL1101 can be allocated to two different indoor stations (parallel serial numbers 1
and 2).
Initiate
programming
Enter
Indoor station with this
serial number has
been found
 incorrect serial
number
 SNo is already allo-
cated
* WE = factory setting

Select sound profile and ring tones

For 8 different incoming calls (door call from 2 different front-door stations, floor call, inter-
nal call, sub-door calls 1 to 4) different ring tones can be selected.
Initiate
programming
sound profile selec-
tion
enter
TCS TürControlSysteme AG, TCS Hotline Germany:
FAX: +49 (0) 41 94/ 9 88 129  Mail: hotline@tcsag.de
11
If not yet done
* 11 # SNo 1 #
...
* 12 # SNo 2 #
...
 SNo 1 and 2: 0 to 999999
 If SNo = 0 is entered, parallel allocation is
deactivated.
 a positive acknowledgement tone sounds,
red LED is ON for 3 s.
 then LED red blinks.
The FIL1101 is allocated parallel to the indoor
station.
A negative acknowledgement tone sounds
when pressing the #-key.
The red LED blinks fast for 3 s,
then blinks again.
If not yet done
* 20 # sound profile #
sound profile
= 0 ISH1030
= 1 ISH3030
= 2 Skyline
(SNo = serial
number of
the indoor
(WE* = 0)
station)
(WE = 1)
Subject to technical changes.
FIL1101 UK 1A mi