System Controller - Xilinx KCU1250 User Manual

DONE LED
The DONE LED DS17 (callout 12,
FPGA. When the DONE pin is High, DS17 lights up indicating the FPGA is successfully
configured.
INIT LED
The dual-color INIT LED DS3 (callout 13,
During FPGA initialization, the INIT LED illuminates RED. When FPGA initialization has
completed, the LED illuminates GREEN.

System Controller

The KCU1250 board utilizes a Xilinx XC7Z010-CLG225 Zynq-7000 AP SoC U38 (callout 33,
Figure D-1) system controller that can be used to:
• Configure the FPGA using predefined selection of configuration bit files on an SD card
using 8-bit SelectMAP configuration
• Select the output frequencies of the SuperClock-2 module
• Monitor the onboard power system (PMBus)
See Appendix D, System Controller
System Controller Reset
The SYS_POR pushbutton SW4 (callout 9,
controller Power-On Reset (SYS_POR). When SYS_POR is reasserted, the system controller is
reconfigured using the controller design stored on an attached SPI flash.
System Controller Status LEDs
DS1, DS12, DS16, and DS27 (callout 35,
DONE, STATUS, and ERROR status, respectively.
KCU1250 User Guide
UG1057 (v1.0) December 19, 2014
Chapter 1: KCU1250 Board Features and Operation
Figure 1-2) indicates the state of the DONE pin of the
Figure 1-2) indicates the FPGA initialization status.
for information on the system controller menu options.
Figure 1-2) asserts the active-Low system
Figure 1-2) show the system controller INIT_B,
www.xilinx.com 20
Send Feedback