Battery Removal & Installation - Stealth Cam FLX CAMERA Instruction Manual

BATTERY REMOVAL & INSTALLATION
To remove the batteries from the unit; open the case and press
the EJECT button on the lower right hand corner. This will
cause the battery tray to be released and slide downwards.
To reinsert the battery tray; position the tray so the base of the tray matches with the opening at
the bottom of the camera. The tray is notched so that incorrect insertion of the battery tray is not
possible. With the orientation correct simply slide the battery tray into its final locked position.
Should the battery tray not willingly slide into it destination, remove the tray and examine the
area of possible debris that may be causing the issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
Remove batteries from the tray if the unit will not be in use for extended period of time.
www.stealthcam.com
877-­‐269-­‐8490
New, Alkaline or Lithium, 'AA' batteries must be
inserted with the orientation as shown on the tray. As
with most electronic devices the negative ( -­‐ )
orientation of the batteries should be against the
springs. Failure to insert the batteries properly will
cause damage to the unit. Remember camera uses
(12)'AA' batteries, six on each side.
**WARNING**
Do not mix new and old batteries.
26
Page