Battery Removal & Installation - Stealth Cam STC-PX36NG Series Instruction Manual

BATTERY REMOVAL & INSTALLATION
To remove the batteries; open the case and slide thte battery compartments doors outwards.
(See page 5 and 6)
New, Alkaline or Lithium, 'AA' batteries must be inserted with the orientation as shown in the
compartment. As with most electronic devices the negative ( -­‐ ) orientation of the batteries
should be against the springs. Failure to insert the batteries properly will cause damage to the
unit.
Once batteries are properly installed and with the orientation correct, simply slide the battery
compartment doors back into its final locked position. Should the battery doors not willingly slide
into it destination, remove them and examine the area of possible debris that may be causing the
issue.
NOTE: Replacing the batteries will not reset the cameras current configurations.
**WARNING**
Do not mix new and old batteries.
Remove batteries from the tray if the unit will not be in use for extended period of time.
14
www.stealthcam.com Page
877-­‐269-­‐8490