Table of Contents
Advertisement
4. Attach the power cable, the SCSI terminator, the HDD fault LED
cable, and the system board connector cable to the backplane
board and attach the other end of the connector cable to the
system board. For the location of the SCSI connector, please
refer to the system board manual.
Single Hot-swap Cage Configuration
Power connector
SCSI Terminator
There are two kinds of HDD Fault LED cable
supplied. The cable with two 4-pin connector
should be use with AcerAltos 1100 and
AcerAltos 11000 systems. The other cable
with AcerPro Station 7000.
System Housing
System board
connector cable
CN3: Connect to system
board's HDD Fault LED
1-11
Advertisement
Table of Contents
