Parkside ZKGS 2100 Operation And Safety Notes page 10

Anleitung_ZKGS_2100_4300688:_
GB
10.Don't abuse cord
– Never carry tool by cord or yank it to
disconnect it from receptacle. Keep cord
from heat, oil and sharp edges.
11.Secure work
– Use clamps or a vise to hold work. It's
safer than using your hand and it frees both
hands to operate tool.
12.Don't overreach
– Keep proper footing and balance at all
times.
13.Maintain tools with care
– Keep tools sharp and clean for better and
safer performance. Follow instructions for
lubricating and changing accessories.
Inspect tool cords periodically and, if
damaged, have repaired by authorized
service facility. Inspect extension cords
periodically and replace if damaged. Keep
handles dry, clean and free from oil and
grease.
14.Disconnect tools
– When not in use, before servicing,
and when changing accessories such as
blades, bits and cutters.
15.Remove adjusting keys and wrenches
– Form the habit of checking to see that
keys and adjusting wrenches are removed
from tool before turning it on.
16.Avoid unintentional starting
– Don't carry plugged-in tool with finger on
switch. Be sure switch is off when plugging
in.
17.Outdoor use extension cords
– When tool is used outdoors, use only
extension cords intended for use outdoors
and so marked.
18.Stay alert
– Watch what you are doing. Use common
sense. Do not operate tool when you are
tired.
19.Check the appliance for damage
– Before using the equipment further, check
that safety equipment or slightly damaged
parts are in good working order and
function correctly. Check that the moving
parts are functioning correctly and that they
are not clamped or damaged. All parts must
be correctly assembled to ensure safe use
of the equipment.
10
25.11.2008 8:30 Uhr Seite 10
Damaged safety devices and parts must be
repaired or replaced by experts in a
customer service workshop, unless
otherwise stated in the manual. Damaged
switches must be replaced in a customer
service workshop. Do not use equipment for
which the on-off switch does not correctly
function.
20.Warning
– The use of any other accessory or
attachment other than recommended it this
operating instruction or the Einhell catalog
may present a risk of personal injury.
21.Have your tool repared by an expert
– This electric appliance is in accordance
with the relevant safety rules repairing of
electric appliances may be carried out only
by experts otherwise it may cause
considerable danger for the user.
22.Connect the dust extraction device
– Wherever there are facilities for fitting a
dust extraction system, make sure it is
connected and used.
2.3 Special Safety instructions for the
equipment
1. Safety measures
Replace worn out table inserts.
Use only blades which are recommended
by the manufacturer and comply with EN
847-1.
If necessary, wear appropriate personal
safety equipment. This could include:
- Ear protection to reduce the risk of
hearing impairment;
- Dust mask to reduce the risk of
dangerous dust inhalation.
- When handling saw blades and raw
materials, wear gloves. Saw blades must
be carried in a container wherever
practicable.
The following factors can influence the
release of dust:
- Worn out, damaged or flawed saw blades
- Recommended extractor power of the
vacuum extractor system: 20 m/s
- The workpiece should be handled
according to the instructions
Saw blades made from high-alloy high-