Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - Parkside ZKGS 2100 Operation And Safety Notes

Anleitung_ZKGS_2100_4300688:_
GB
8.8 Transport (Fig. 1 – 3)
Tighten the locking grip (13) to lock the
turntable (16).
Press the release lever (3), push the
machine head (5) to the rear and lock it with
the locking bolt (25). The saw is now locked
in its lower position.
Secure the drag function of the saw in its
rear position using the fixing screw for the
drag guide (24).
Carry the equipment by the fixed saw table
(17).
When reassembling the equipment proceed
as described under section 7.2.
8.9 Using the laser (Fig. 21-23/Item. 33)
To switch on: Move the ON/OFF switch of the
laser (34) to the "1" position. A laser line is
projected onto the material you wish to
process, providing an exact guide for the cut.
To switch off: Move the ON/OFF switch of the
laser (34) to the "0" position.
Setting the laser: Slacken the screws (37) to
adjust the laser. Retighten the screws after you
have made the adjustment. Important. Never
look directly into the laser beam!
Replacing the battery: Switch off the laser
(33). Remove the battery compartment cover
(36). Remove the batteries and replace with
new batteries (2 x 1.5 Volt Type R03, LR 03
Micro, AAA) Check that the battery terminals
are positioned correctly when inserting new
batteries. Close the battery compartment (35)
again.

9. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
18
25.11.2008 8:30 Uhr Seite 18
10. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device.
10.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
10.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
10.4 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
For our latest prices and information please go
to www.isc-gmbh.info