Ksw-63/Ksw-64/Hn-407 Board - Sony PMW-50 Service Manual

2-11.

KSW-63/KSW-64/HN-407 Board

Preparation
1. Remove the LCD assembly. (Refer to
2. Remove the top/bottom panel assembly. (Refer to
3. Remove the front panel assembly. (Refer to
4. Remove the rear panel assembly. (Refer to
5. Remove the bottom frame. (Refer to
6. Remove the front frame assembly. (Refer to
7. Remove the front bracket assembly. (Refer to
Procedure
1. Remove the screw and lift up the KSW-64 board to the direction of the arrow.
2. Disconnect the harness from the connector CN100 on the KSW-64 board.
Note
When installing the KSW-64 board, fit the two bosses with the two holes.
3. Remove the screw and lift up the KSW-63 board to the direction of the arrow.
4. Disconnect the HN-407 board and the harness from the two connectors CN300, CN306 on the KSW-63 board.
5. Remove the tape 50 and the cushion (HN-407) from the HN-407 board.
PMW-50
"2-2. LCD Assembly")
"2-3. Top/Bottom Panel
"2-4. Front Panel Assembly/SxS
"2-6. Rear Panel
"2-7. Bottom Frame")
"2-8. Front Frame
"2-9. IO-256
Holes
CN100
Harness
Bosses
Assembly")
Lid")
Assembly")
Assembly")
Board")
P2 x 4
KSW-64 board
2-22