Front Frame Assembly - Sony PMW-50 Service Manual

2-8.

Front Frame Assembly

Note
The following parts are not reusable. Prepare new parts in advance.
• DCP conductive tape (D)
Preparation
1. Remove the LCD assembly. (Refer to
2. Remove the top/bottom panel assembly. (Refer to
3. Remove the front panel assembly. (Refer to
4. Remove the rear panel assembly. (Refer to
5. Remove the bottom frame. (Refer to
Procedure
1. Disconnect the flexible flat cable and the HN-407 board from the two connectors on the AU board.
2. Disconnect the harness from the connector CN202 on the RE-298 board.
3. Disconnect the two fine-wire coaxial cables from the two connectors on the DPR board.
PMW-50
"2-2. LCD Assembly")
"2-3. Top/Bottom Panel
"2-4. Front Panel Assembly/SxS
"2-6. Rear Panel Assembly")
"2-7. Bottom Frame")
Assembly")
Lid")
2-13