Table of Contents
Advertisement
2-9.
IO-256 Board
Preparation
1.
Remove the LCD assembly. (Refer to
2.
Remove the top/bottom panel assembly. (Refer to
3.
Remove the front panel assembly. (Refer to
4.
Remove the rear panel assembly. (Refer to
5.
Remove the bottom frame. (Refer to
6.
Disconnect the harness from the connector CN202 on the RE-298 board. (Refer to
Procedure
1.
Disconnect the harness from the connector CN202 on the RM-298 board.
2.
Remove the tape 50.
RE-298 board
CN202
Harness
3.
Disconnect the harness from the connector CN100 on the RM-239 board.
4.
Disconnect the harness from the connector CN104 on the IO-256 board.
5.
Remove the two screws to detach the GND plate (RM) and the front bracket assembly.
Front bracket assembly
GND plate (RM)
P2 x 4
CN100 (RM-239 board)
Note
Carefully handle the GND plate (RM) because it is likely to be deformed.
PMW-50
"2-2. LCD
Assembly")
"2-3. Top/Bottom Panel
"2-4. Front Panel Assembly/SxS
"2-6. Rear Panel
Assembly")
"2-7. Bottom
Frame")
Harness
IO-256 board
CN104
P2 x 4
Assembly")
Lid")
"2-8. Front Frame
Assembly")
Tape 50
Harness
2-16
Advertisement
Table of Contents
