D-Link COVR-1900 User Manual page 67

Section 3 - Configuration
Enable or disable the DHCP server.
Status
Enter the starting and ending IP addresses for the DHCP
DHCP IP Address
server's IP assignment. Note: If you statically assign IP addresses
Range
to your computers or devices, make sure the IP addresses are
outside of this range or you may have an IP conflict.
Enter the length of time for the IP address lease in minutes.
DHCP Lease Time
Enable this feature to broadcast your network's DHCP server
Always Broadcast
to LAN/WLAN clients.
You may set the port speed of the Internet port to 10 Mbps,
WAN Port Speed
100 Mbps, 1000 Mbps, or Auto (recommended).
Enable or disable Universal Plug and Play (UPnP). UPnP
UPnP
provides compatibility with networking equipment, software,
and peripherals.
Enable to allow IPv4 multicast traffic to pass through the router
IPv4 Multicast Streams
from the Internet. This is enabled by default.
Enable to allow IPv6 multicast traffic to pass through the router
IPv6 Multicast Streams
from the Internet. This is enabled by default.
D-Link COVR-1900 User Manual
DHCP Server
Advanced Settings
63