Replacing The Filter; Removing The Filter - DeLonghi DINAMICA plus ECAM37095 Instructions For Use Manual

2. Access the menu as described in section "6.1 Access the
settings menu";
3. Press "WATER FILTER"; "TURN DATE INDICATOR TO NEXT 2
MONTHS" (fig. 37): turn the date disk to display the next
2 months of use.
4. Press ;
37
Please note
The filter lasts about two months if the machine is used normal-
ly. If the coffee machine is left unused with the filter installed, it
will last a maximum of 3 weeks.
5. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (fig.
38): To activate the filter, run tap water through the hole
in the filter as shown in the figure until water comes out
of the openings at the side for more than a minute. Press
;
6. Extract the tank (A17) from the machine and fill with
water.
7. "IMMERSE FILTER TO" "EXPEL AIR BUBBLES" (fig. 39): Insert
the filter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape. Press
8. "INSERT FILTER" "IN HOUSING": Insert the filter (D4) in the
filter housing (fig. 36) and press as far as it will go. Press
;
9. "INSERT WATER TANK": Close the tank with the lid (A17),
10. "POSITION 0.5L CONTAINER" "OK TO ENABLE FILTER"
The filter is now active and the coffee machine can be used.

17.2 Replacing the filter

Replace the filter (D4) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press
To replace the filter later, press
bol appears on the display to remind you that the filter needs
replacing. To replace, proceed as follows:
1. Extract the tank (A17) and exhausted filter;
2. Remove the new filter from the packaging;
38
3. Access the menu as described in section "6.1 Access the
4. Follow the operations described in the previous section
The filter is now active and the coffee machine can be used.
Please note:
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

17.3 Removing the filter

If you want to use the machine without the filter (D4), you must
remove it and notify the machine of its removal. Proceed as
follows:
1. Extract the tank (A17) and exhausted filter;
2. Access the menu as described in section "6.1 Access the
;
3. PRESS "WATER FILTER";
4. Press the selector corresponding to " REMOVE WATER
5. "CONFIRM FILTER REMOVAL": press
6. "FILTER REMOVED": the change has been saved. Press
Please note:
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the filter even if
39
the message has not yet been displayed.
20
then put the tank back in the machine (fig. 5);
(fig. 7): Place the container under the hot water spout
(D6) and press
automatically.
and follow the instructions from point 5.
settings menu";
from point 3.
settings menu";
FILTER";
press to go back to the settings menu);
to go back to the homepage.
. Delivery begins and stops
. The sym-
(or