Table of Contents
Advertisement
USER GUIDE
6.4
MAKING THE CABLE CONNECTIONS
1. Place the projector on a stable, hard surface at the desired distance
from the projection screen.
2. Connect the computer source equipment to the computer connector
port of the LCD projector:
- PC:
Insert the end of the VGA cable marked ' LCD' into the
COMPUTER connector port on the LCD projector. Connect the
connector marked ' Monitor' onto your monitor cable, and the
connector marked ' VGA' , into the VGA port on the PC unit. If you
do not intend to use a monitor then just leave the short cable
section unconnected.
- MAC: Follow the above sequence, but insert applicable MAC cable
adapters as marked at the computer and monitor ends of the VGA
cable.
- WS:
Follow the above procedure, but either use BNC type cable, attach
directly to monitor and through your original monitor cable to
computer, or alternatively use VGA cable and 13W3 adapters at
computer and monitor ends.
3. Connect video sources if required, using the supplied A/V cable. If
necessary use SCART adapter.
4. Connect one end of the mouse cable marked ' LCD' into the mouse port
on the LCD projector and the other end marked ' MA' (Mouse Adapter)
into the appropriate mouse adapter, determined by which mouse type
you are using.
5. Ensure the ventilation grills on the LCD projector are not obstructed.
Apply mains power to the projector. Remember to switch on the unit at
the Power ON/OFF switch!
6. Apply mains power to the various items of source equipment.
Your LCD projector is now fully connected up. Before use for your
presentation, refer to the next section on Image Adjustments to attain the
highest quality of projected image.
XGA LCD MULTIMEDIA PROJECTOR
17
Advertisement
Table of Contents
