Making The Connections - Ask Proxima A6 Compact User Manual

USER GUIDE

6 MAKING THE CONNECTIONS

The projector may be connected to different equipment. The following
sections describe in detail how to connect to these systems.
See the illustration on the rear of the quick set-up card on
how the various system parts connect together.
Be aware of static electricity that may build up in the dry
season and when operating on synthetic carpets. Discharge
any static electricity by touching a metallic surface before
you start.
Place the projector on a table at a suitable distance to the projection screen.
Select a screen with good reflectivity and avoid direct sunlight shining in.
Place the projector so that the image is visible to the whole audience, and
so that the unit does not obstruct the view.
Various cables are supplied or optionally available to connect to different
sources. Follow the list below in numerical order for a trouble-free set-up!
1. SWITCH OFF all equipment before making all the connections.
2. COMPUTER GRAPHICS ADAPTER.
Computer graphics adapters use different connectors depending on the
actual computer system in use. Adapters are used at the computer end
for non-VGA type connections
PC. Use the computer cable directly to connect to the graphics port.
If needed, connect your monitor to the MONITOR connector on the
projector.
MAC. Connect the optional MAC adapter marked COMPUTER on
the computer end to adapt to the graphics-port. The optional
adapater marked MONITOR is connected to the monitor cable if
needed.
WORKSTATION. Connect the optional 13W3 or BNC adapter
marked COMPUTER on the computer end to adapt to the graphics-
port. The optional 13W3 or BNC adapter marked MONITOR is
connected to the monitor cable if needed.
XGA LCD PROJECTOR
13