Table of Contents
Advertisement
USER GUIDE
7
SETTING UP THE LCD PROJECTOR
Switch off all equipment before connecting the projector. Be aware of static
electricity that may build up, especially in the dry season and when
operating on synthetic carpets. Discharge any static electricity by touching
a metallic surface before you start.
Do not cover the air inlet in front or the air outlet on top of the
projector housing, as this will block the cooling. Also make sure
to place the projector on a flat, hard surface to avoid blocking
the bottom air inlet. A thermal safety switch will cut off the
illumination system if the ventilation is reduced.
Place the LCD projector on a table at a suitable distance from the
projection screen in order to get the desired size of the projected image on
the wall (see illustration below). Adjust the projection lens for a sharp
image by turning the focusing wheel on the lens barrel. Project on a flat
surface screen with high reflectivity to get a bright and undistorted,
rectangular image. Best results are obtained in a dimmed room with no
direct sunlight shining in.
DISTANCE
WIDTH
HEIGHT
DIAGONAL
1.00m/
"
2.00m/ 78"
0.64m/ 24"
1.23m/
0.48m/
"
0.92m/ 36"
0.80m/ 32"
1.53m/
3.00m/
"
1.80m/
1.36m/
"
2.27m/ 89"
12
LCD PROJECTOR
"
4.00m/
"
2.40m/ 94"
"
1.80m/
3.00m/
"
"
"
Advertisement
Table of Contents
