Table of Contents
Advertisement
USER GUIDE
Insert a new lamp. Push the lamp holder all the way until it positively stops.
Twist the handle on the small screw to lock the lamp holder. Fold the large
handle and remount the lamp lid. Mount all the screws holding the lamp lid
tightly.
Use only original lamp and holder as specified. The lamp is
individually adjusted with the holder to maintain optimum
illumination. Replacement using a different lamp may result
in poor illumination, malfunction (potentially explosion) and
will void any warranties.
To reset the lamp timer, invoke the menu system under OPTIONS,
SERVICE, LAMP TIMER RESET. You need to confirm that you actually
intend to reset the lamp timer, or cancel if you accidentally invoked the
function.
13.3
THE REMOTE CONTROL
The infrared remote control requires little maintenance.
The trackball element may be cleaned occasionally with a damp (not wet)
cloth. To take out the ball, twist the ring holding the ball anti-clockwise.
Having taken out the ball, you may also clean the trackball interior using a
damp (not wet) cotton swab.
To change the batteries, open the battery holder on the rear of the handset.
Remove the old batteries and dispose of carefully. Insert new batteries of
the type described in the Technical Data section, observing the polarity
instructions inside the battery holder, and close the clip-shut door. Test that
the remote control functions correctly by pressing the LIGHT key to see if
the backlighting operates properly.
SVGA DLP PROJECTOR
38
Advertisement
Table of Contents
