Table of Contents
Advertisement
USER GUIDE
SYMPTOM
The whole
image appears
to be unstable
or misplaced
Cooling fan is
not working
The remote
control is not
working
The desktop
mouse is not
working
SOLUTION
If the image is scaled, press SCALE to return to
the default mode.
Adjust the frequency and tuning settings
(instability), or the image position settings
(misalignment).
Check that you are using a source with
compatible resolution.
The projector may be connected to a source with
a non-standard computer (or video card). Adjust
the frequency and position of the image.
See the Image Adjustment section for details
Check that the Power ON/OFF switch is ON.
If the fan does not work the projector must not
be used and should be returned to your dealer
for repair.
Check the batteries by pressing LIGHT on the
remote control. The keypad shall then be
backlighted by a red light.
Check that the green LED on the projector is
blinking when you press any one of the keys on
the remote control.
Make sure you point the remote control at the
projection screen or directly at the IR receiver
The maximum range of the IR transmitters is
15m (50 feet) - Are you standing close enough?
If the effective range of the transmitters is
significantly reduced, the remote control needs
new batteries.
Remember that the mouse must be connected,
and the projector switched on, before the
computer source is switched on.
Are the mouse cable and mouse adapter
connections secure?
Check the mouse driver settings on the computer
You must boot the computer after the cable has
been connected for it to recognise the mouse. If
you are unsure whether this was the case, reboot
your computer.
35
SVGA DLP PROJECTOR
Advertisement
Table of Contents
