Startup And Shutdown; Operation Modes - Dimplex DPRC20ECO-A Instruction Manual

Settings
START-UP AND SHUTDOWN
Press POWER to turn the unit on.
The unit runs in FAN as default.
Press MODE button to select the desired operation mode.
Press POWER again to turn off the power.

OPERATION MODES

The unit has five operation modes: Cool, dry, fan, heat, sleep.
1. Cooling your room
Select the cool mode to lower the temperature in your room.
Press MODE button repeatedly until the LED of COOL operation lights
up.
Press UP/DOWN button to adjust the temperature which is displayed on
the screen. The temperature can be set between 16
Press SPEED button repeatedly until the desired fan speed indicator
lights up.
To control the direction of the air flow horizontally, please adjust the inner
louver by hand.
Note: The air conditioner stops if the room temperature is lower than selected
temperature.
2. Heating your room (Optional for Heating Function Unit only)
Press MODE button repeatedly until the LED of HEAT operation lights up.
Press UP/DOWN button to set the temperature higher than the room
temperature. The fan speed can also be set.
Note: The drainage hose should be attached to the unit for continuous
operating.
3. Ventilating your room
Press MODE button repeatedly until the LED of FAN operation lights up.
In ventilation mode the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.
4. Drying your room
Press MODE button on the control panel or remote control until the
dry indicator lights up. The fan speed is unable to be adjusted during
Drying operation. User should connect the hose to the drain outlet at the
bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot be
adjusted.
15429_Dimplex DPRC20ECO-A Manual.indd 15 15429_Dimplex DPRC20ECO-A Manual.indd 15
C and 32 C.
0 0
15
7/09/20 4:34 PM 7/09/20 4:34 PM