Taking Out The Spare Wheel; Tool Storage - CITROEN C4 Spacetourer Handbook

Taking out the spare wheel

F Fold back the concertina board and install
the third row seat, on the left-hand side (if
your vehicle is equipped with it).
F Lift the pre-cut section of carpet to remove
the fixing winch nut from the spare wheel.
F With the extension 6 placed on the end of
wheelbrace 1, "tighten" the nut to unwind
the winch cable until the spare wheel is
flat on the ground. Unwind as much as
necessary in order to access the wheel
easily.
F Detach the assembly of wheel and box from
the rear of the vehicle.
F Straighten the spare wheel to access tool
box (A).
F Detach the connecting piece from the cover
of the tool box (B – C).
F Pass the connecting piece through the
wheel hub to release it (D).
In the event of a breakdown
F Press the tab, slide the lid on the box up
to the middle and remove it to access the
other tools (jack and alloy wheel bolt cover
removal tool).

Tool storage

F Put the tools back in the box and store the
box in the boot of the vehicle.
F Reel in the winch by turning the key in
the clockwise direction: once the cable is
completely reeled in, you should no longer
feel any resistance.
F Store the rest of the tools in the storage
areas in the boot.
The wheel with the punctured tyre cannot
be fitted under the vehicle. It must be
stored in the boot. Use a cover to protect
the interior of the boot.
8
215