Towing; Reconnecting The (+) Terminal; Following Reconnection Of The Battery - CITROEN C4 Spacetourer Handbook

Hide thumbs Also See for C4 Spacetourer:
Table of Contents

Advertisement

In the event of a breakdown

Reconnecting the (+) terminal

F Raise the lever A fully.
F Refit the open clamp B on the (+) terminal.
F Push the clamp B fully down.
F Lower the lever A to lock the clamp B.
Do not force the lever as locking will not
be possible if the clamp is not positioned
correctly; start the procedure again.
Following reconnection of the
battery
Following reconnection of the battery, switch on
the ignition and wait 1 minute before starting to
permit initialisation of the electronic systems. If
minor problems nevertheless persist following
this operation, contact a CITROËN dealer or
a qualified workshop.
234
Referring to the corresponding section, you
must yourself reinitialise (depending on
version):
-
the remote control key,
-
the electric blind(s),
-
etc.
Versions equipped with Stop & Start are
fitted with a 12 V lead-acid battery of
specific technology and specification.
Its replacement should be carried out
only by a CITROËN dealer or a qualified
workshop.
The Stop & Start system may not be
operational during the trip following the
first engine start.
In this case, the system will only be
available again after a continuous
period of immobilisation of the vehicle,
a period which depends on the exterior
temperature and the state of charge of the
battery (up to about 8 hours).

Towing

Procedure for having your vehicle towed or for
towing another vehicle using the towing eye.
Access to tooling
The towing eye is installed in the boot under
the floor.
The tool for opening the front protective cover
is fixed to the towing eye.
To access it:
F open the boot,
F lift the floor and remove it,
F remove the towing eye from the holder.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents