Lubricating The Upper Handle; Adjusting The Self-Propel Drive - Toro Super Bagger Operator's Manual

•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Lubricating the Upper
Handle
Service Interval: Yearly
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant.
1. Spray the outer plastic end of the inner handle
(Figure 46).
Figure 46
Note:
Use the straw that comes with the spray
can to direct the spray.
2. Push the upper handle fully down and spray the
inner plastic surface of the outer handle
47).
Figure 47
until the oil level on the dipstick
Adjusting the Self-Propel
Drive
If your machine does not self-propel properly, adjust
the self-propel-drive cable.
1. Loosen the nut on the cable mount
1. Cable mount
2. Pull the upper handle back fully rearward.
Note:
refer to
3. Pull the cable jacket downward until you remove
the slack in the exposed cable
g010349
(Figure
1. Exposed cable
4. Push the cable jacket upward 3 mm (1/8 inch).
Note:
g010350
side of the black cable mount and measure how
far the upper end of the cable jacket moves
(Figure
20
Figure 48
If the handle does not move smoothly,
Lubricating the Upper Handle (page
Figure 49
You can place a ruler against the upper
50).
(Figure 48).
g010351
20).
(Figure 49).
g007744