Servicing The Air Filter; Changing The Engine Oil - Toro Super Bagger Operator's Manual

Servicing the Air Filter

Service Interval: Before each use or daily
Yearly
1. Press down on the latch tabs on top of the
air-filter cover (Figure
Figure 42
1. Latch tabs
2. Open the cover.
3. Remove the air filter
Figure 43
4. If the air filter is damaged or is wet with oil or
fuel, replace it.
5. If the air filter is dirty, tap it on a hard surface
several times or blow compressed air less than
207 kPa (30 psi) through the side of the filter
that faces the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
6. Remove dirt from the air-filter body and cover
using a moist rag. Do not wipe dirt into the
air duct.
7. Install the air filter.
8. Close the cover.
42).
(Figure 43).

Changing the Engine Oil

Service Interval: Yearly
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
g002902
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
4. Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (Figure
g002903
5. After draining the used oil, return the machine to
the operating position.
6. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7. Wait 3 minutes for the oil to settle in the engine.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
10. Read the oil level on the dipstick
19
0.55 L (18.6 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 44
44).
Figure 45
(Figure
18).
44).
g010271
g010272
16).