Adjusting The Upper Handle Height; Adjusting The Cutting Height - Toro Super Bagger Operator's Manual

Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note:
You cannot raise the upper handle higher than
the angle of the lower handle.
1. Loosen the upper-handle knob
Figure 17
2. Move the upper handle to the desired position
(Figure 18).
Figure 18
3. Tighten the upper handle knob as tight as you
can (Figure 19).
Figure 19
Adjusting the Cutting
Height
Adjust the cutting height as desired. Set all the
cutting-height levers to the same height. To raise and
lower the machine, refer to
(Figure 17).
g010334
1. Raise the machine
2. Lower the machine
Important:
(1 inch); 38 mm (1-1/2 inch); 51 mm (2 inches); 64
mm (2-1/2 inches); 83 mm (3-1/4 inches); 95 mm
(3-3/4 inches); 108 mm (4-1/4 inches).
g010265
g010352
10
Figure 20.
Figure 20
The cutting height settings are 25 mm
g010264