Lubricating The Upper Handle - Toro Super Bagger 20897 Operator's Manual

9. Pour about 3/4 of the crankcase capacity of oil in the
crankcase.
Note: Max fill: 0.55 l (0.58 qt), type: SAE 30 detergent
oil with an API service classification of SF, SG, SH,
SJ, SL, or higher.
10. Wipe the dipstick clean with a clean cloth.
11. Insert the dipstick into the oil-fill tube, but do not
screw it in.
12. Remove the dipstick and read the oil level on the
dipstick (Figure 39).
Figure 39
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and then repeat steps 10 through 12 until the oil
level is at the Full mark on the dipstick.
•
If the oil level is too high, drain the excess oil until
the oil level is correct as shown in Figure 39.
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
13. Install the dipstick into the oil-fill tube securely.
14. Dispose of the used oil properly at a local recycling
center.

Lubricating the Upper Handle

Service Interval: Yearly
Lubricate the left and right sides of the upper handle with a
low-viscosity silicone spray lubricant.
1. Spray the outer plastic end of the inner handle
(Figure 40).
Note: Use the straw that comes with the spray can to
direct the spray.
2. Push the upper handle fully down and spray the inner
plastic surface of the outer handle (Figure 41).
17
Figure 40
Figure 41