Fluke 4180ETRS Operator's Manual page 42

4180ETRS
Operators Manual
SYST:PASS:CDIS
Disable access to password protected setting commands.
Example: SYST:PASS:CDIS
This command has no response.
This command disables the system password protection.
SYST:PASS:CEN [n]
Enable access to password protected setting commands, where "n" is a four digit pass- word.
Range = {0000 - 9999};
Example: SYST:PASS:CEN 1234
This command has no response.
This command enables the system password. This password must be enabled in order to use the
conditionally-protected commands. When the power of the Product is cycled, system-password
protection is disabled.
SYST:PASS:CEN:STAT?
Read the access state of password protected setting commands.
Example: SYST:PASS:CEN:STAT?
Response: 0
This command reports the current status of the system password.
SYST:PASS:NEW n
This command is unconditionally protected, which requires a password to set it.
Set the password, where n is the new four-digit password. Range = {0000 - 9999}; Default: 1234
Example: SYST:PASS:NEW 1234
This command has no response.
This command allows the user to set the system password.
SYST:PASS:PROT[?] [0|1]
Read or set password protection level., [0] = low, [1] = high
Read Example: SYST:PASS:PROT?
Response: 0
Set Example: SYST:PASS:PROT 1
38
Note