Configuring The Port Expansion Unit With The Cli - 3Com 3C421600A Quick Setup Manual

2-8 C 2: C
HAPTER ONFIGURING THE
Configuring the
Port Expansion Unit
with the CLI
RAS 1500 S
OFTWARE
>>> Enter the IP address of the default gateway []?
192.168.1.20
The metric or "hop count" tells the RAS1500 how far the
default router is from the RAS1500.
>>> What metric should be applied to the default gateway [1]?
>>> Do you want to configure DNS for this RAS1500 [yes]?
>>> What is the address of the main DNS server for this
RAS1500 []?
192.168.1.2
>>> What is the default DNS domain name for this RAS1500 []?
yourcompany.com
You can either assign each user his or her own address or you
can set aside a pool of addresses for dynamic allocation.
>>>Do you want to set up an address pool [yes]?
The address pool is a continuous range of addresses.
>>>Enter the name of your IP address pool [ippool]:
>>>What is the initial address in the pool []? 192.168.1.10
>>>How many addresses should be the pool [127]? 8
It is possible to restrict access to the TFTP server to a
specific system or a list of systems. Quick Setup will allow
you to enter one system that is allowed or allow all systems
access
>>>Do you want to allow all systems to access the TFTP server
[no]? y
IP setup is completed.
The RAS 1500 stack does not immediately recognize the removal or
substitution of port expansion units.
To remove and substitute another port expansion unit to an existing
setup, issue the save all command at the CLI prompt. Then issue the
reboot command at the CLI prompt.
After the reboot process occurs, the router unit automatically recognizes
each port expansion unit attached to it.