Initial Configuration From Unix-Based Platforms; Accessing The Cli - 3Com 3C421600A Quick Setup Manual

Superstack ii remote access system
Hide thumbs Also See for 3C421600A:
Table of Contents

Advertisement

Initial
Configuration from
UNIX-based
Platforms

Accessing The CLI

Configuration Interface from PC and UNIX-based Platforms" for
configuration procedures using this browser-based tool.
The section below describes how you will perform initial configuration for
your RAS 1500 using the CLI Quick Setup. The RAS 1500 must be
connected to the same LAN segment as the workstation and cannot have
an IP address. The CLI Quick Setup will let you set up initial required
configuration for the system. Although you may then continue to set up
other features through the CLI, 3Com recommends that you continue
your configuration by using the web-based Web Configuration Interface
described in one of the sections that follow in this chapter.
Before you can use the CLI Quick Setup to configure the RAS 1500 you
need to access the CLI. An terminal emulation program (8 date bits, no
parity and 1 stop bit) is required. You will configure the serial port on the
UNIX station.
The CLI Quick Setup starts automatically after the boot process of an
unconfigured device.
If the RAS 1500 does not ask you if you want to run the quick setup
program, the RAS 1500 has already been configured. In this case, type:
and answer
delete config
operation. Note however, that all configuration information, such as
users, will be erased.
The quick setup is as follows:
ras1500> Welcome to the RAS1500 Quick Setup
The RAS1500 Quick Setup will let you set up simple
configuration for your whole system or different portions of
the system.
Do you want to continue with RAS1500 Quick Setup? y
There are two ways to proceed: You can set up only the basic
configuration, which will allow you to continue with
the browser-based Web Configuration Interface. Or you
can configure a simple configuration for IP and IPX and
AppleTalk.
Do you want to configure only enough to use the web-based
?
system [yes]
y

Initial Configuration from UNIX-based Platforms

when you are prompted to verify this
yes
2-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Remote access system 1500

Table of Contents