Powering The Ras 1500 On Or Off; Powering On The Ras 1500; Powering Off The Ras 1500; Connecting The Stacknet Cables - 3Com 3C421600A Quick Setup Manual

1-10 C 1: I
HAPTER NSTALLING THE
Powering the
RAS 1500 On or Off
Powering On the
RAS 1500
Powering Off the
RAS 1500
Connecting the
STACKNET Cables
RAS 1500 H
ARDWARE
There is no power switch on the RAS 1500. Use the following steps to
power on or power off the units in a RAS 1500 stack.
To power on the RAS 1500, connect the power cord to the AC power
port of the unit and plug the power cord into the AC power supply
source.
To power off the RAS 1500, disconnect the AC power cord from the AC
power port of the unit.
WARNING: Always disconnect the AC power cord before removing the
cover of the Router, Primary Rate Access Unit, or Port Expansion Unit.
After the Router Unit and Port Expansion Unit AC power cords are
connected, connect the STACKNET cable(s). Connect each Port Expansion
Unit or a single Primary Rate Access Unit to the Router Unit making sure
the connection is secure. Note that the ferrite end must be connected to
the Router Unit as shown.